check out the video to see what I did!
what you need:
- 1mm thick wire (you can usually get this in silver, gold and bronze)
- a round-nosed pliers
- in case your round-nosed pliers doesn't already have that, a side cutter to cut the wire
- a nail file
- something to measure how much wire you approximately need (I used a ring, but you can also use measuring tape or whatever you like)
what you do:
- measure how much wire you need
- cut your wire to the required lengths
- use the round-nosed pliers to form a small eyelet and a bigger loop for your finger
- put the wire through the eyelet and start forming the heart shape
- finish off by forming another eyelet around the wire and then pressing the heart down into a right angle (you may wanna check the video to see more clearly how this works)
- if needed, trim off the rest of the wire
- file around the ends to get smoother edges so you won't poke yourself wearing the ring :)
- all done!
No comments:
Post a Comment